Arch linux iso file invalid
要设置 hostname,将其 添加 到 /etc/hostname, myhostname 是需要的主机名: # echo myhostname > /etc/hostname 例如: # ln -sf /usr/share/zoneinfo/Asia/Shanghai /etc/localtime
![arch linux iso file invalid arch linux iso file invalid](https://www.logikalsolutions.com/wordpress/wp-content/uploads/2021/02/arch-forum-friendly-greeting-1-1024x339.png)
![arch linux iso file invalid arch linux iso file invalid](https://forum.garudalinux.org/uploads/default/optimized/2X/2/2375175399bdadf279efacde031117bbf9f1a085_2_408x500.jpeg)
设置 时区: # ln -sf /usr/share/zoneinfo/ zone/ subzone /etc/localtime The second part of the command installs another program, gptfdisk, that will be needed to perform this configuration.Īs mentioned, we’ve still got some work left to do before we’ve finished installing the boot loader, but we’ve now completed the first step.
Arch linux iso file invalid software#
The first part of this command installs the Syslinux software onto the virtual PC, though we’ll still need to configure it before it will do its job.
![arch linux iso file invalid arch linux iso file invalid](https://syscdn.systranbox.com/how-to-install-arch-linux-on-external-hard-drive-.jpg)
Just like we installed the rest of our system onto our virtual PC’s hard drive, we can now do the same with Syslinux using the following command: I use Syslinux, and so that’s the boot loader I’ll discuss here, though you can find instructions for installing GRUB on the Arch Wiki. You can read up on the selection, but for a relatively basic setup like the one I’ve been describing here, it matters relatively little which you choose. There are several commonly used boot loaders out there.
Arch linux iso file invalid code#
Hex code or GUID (L to show codes, Enter = 8300):Ĭhanged type of partition to 'Linux filesystem'įinally, enter w to write the results, and then q to exit gdisk. This will set you up with your second partition and start it right after the first.
![arch linux iso file invalid arch linux iso file invalid](https://forum.endeavouros.com/uploads/default/original/3X/f/8/f8fb780e02b10819a2334cd93f3d6ec7c379b2cf.jpeg)
然后使用 gdisk 来进行分区,从前到后依次分为: boot, swap, /, home 四个分区, 分别为行如 sda1, sda2, sda3, sda4。Įnter n and accept the default for partition number and first sector. 用 systemd-timesyncd 确保系统时间是正确的: # timedatectl set-ntp true